Seiko SLP240 Bedienungsanleitung PDF herunterladen (Seite 8)

After sending this command, the host must not send any other data for at least 10

milliseconds to allow the printer enough time to change its baud rate. During that

time, the host should change its own baud rate to the specified value.

CMD_SETSPEED (0Dh) – Set print speed mode command

This command is used to set the print speed mode for the Smart Label Printer.

The configuration of the parameter byte is as follows:

Parameter Byte

(mode)

Description

0h Default print speed of the native print engine

1h Adjusted to maximum print speed

Adjusted to slower print speed for high density or

graphic mode

This command is available only for SLP 440 and SLP 450. The printer defaults to

mode 0(Default print speed) on power-up or reset.

CMD_RESET (0Fh) - Reset printer

This causes the printer to perform the equivalent of a power-up reset. The reset

operation will be completed within 3 seconds. After the reset is complete, the

printer sends an XON and sets the RTS signal true.

Note: Do not send CMD_RESET to the printer for at least 20ms after sending

CMD_SETOPTIONS. This could result in corruption of the non-volatile memory.

CMD_MODEL (12h) - Request printer model number

This command is used to request the model of the printer. See "Printer Model

Response Definition" in Section 13 for a description of the response byte.

- 8 -

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Keine Kommentare

Seiko SLP240 Bedienungsanleitung Seite 8