Seiko 7B24 Bedienungsanleitung

Solder Wire Pre-Heater YPH-10 Operation Manual Thank you for purchasing the YPH-10. Read these instructions thoroughly for proper

10 6.4 Parameter showing Description Setting detail Initial value PVS1 PV calibration zero setting Use ▲or▼key to change . 0～150(℃) LoC

11 7. Parts list Parts No. Description Note YPH-HET-ASSY08 HEATER ASSY. for Φ0.8 YPH-HET-ASSY1012 HEATER ASSY. for Φ1.0~1.2 YPH-HET-ASSY

12 Apollo Seiko Ltd. 2271-7 Jinba, Gotenba-shi, Shizuoka, Japan 〒412-0047 TEL: +81-(0)550-88-2828 FAX: +81-(0)55

2 Safety Notes This manual includes the important information to use the device safely. This also includes useful information to prevent avoiding inj

3 INDEX 1. Introduction ... 4 2. Des

4 1. Introduction YPH-10 is the pre-heating solder wire equipment which makes larger diameter solder wire melt smoothly. The diameter of solder wire

5 3. Specification Type YPH-10 Dimension 110 ㎜(W) ×200 ㎜(D) × 100 ㎜(H) Weight Approx. 1.2kg Solder wire diameter Φ1.0～Φ1.6 (Special spec Φ0.8)

6 5. Installation and Connection 5.1 HEATER BODY installation 2. Pass TUBE SET through the each hole of HEATER CAP COVER and HOLDER CAP HEATER

7 *When the PV display shows in green color, the temperature is within the setting range. When it is in red, it is out of its range. (PV value alar

8 ・Input setting mode 6.2 Setting Item Selection screen Setting item selection screen PV calibration “0” setting ・Control setti

9 6.3 Status flow cart Power-on Initial screen Operation mode Setting Item Selection screen “Setting item se